Page 1 of 1

BDP2 Error9

Posted: Sat Oct 27, 2018 8:41 pm
by jimsmy
My BDP2 recently registered error 9 and I followed the suggested checks and a re flash of the CF card. This did not correct the error; I checked the re flashed card in my BDP1 and it worked correctly. I noticed a high pitched noise from around the power supply board that disappears when the unit is activated (green light on).
Any advise would be appreciate.
Thanks,
Jim

Re: BDP2 Error9

Posted: Mon Dec 03, 2018 1:15 pm
by Nazzareno
Hi Jim,
I dont't know about the noise from the power board.
However I experienced the issue you advised once, but simply cycling the power, by disconnecting and reconnecting the power cable, the error was resolved.
Hope this information will be useful for you.
Regards