Page 1 of 1

BDP-Pi Firmware update failing

Posted: Thu Nov 15, 2018 1:33 am
by martydmnt
Screen Shot 2018-11-10 at 1.30.56 PM.png
Screen Shot 2018-11-10 at 1.30.56 PM.png (66 KiB) Viewed 885 times


My Pi is letting me know a new version of the firmware is available. I currently have S2.38 2018-09-11 installed. When I go to Firmware update from the Dashboard, I click on "Update." It dutifully downloads the new firmware but it fails the checksum (see the screenshot). I've tried several times over the past 2 weeks and the result is always the same. Any help is appreciated, thanks!

Re: BDP-Pi Firmware update failing

Posted: Sat Nov 17, 2018 11:52 pm
by Tobogan
Hi, I add exactly the same issue.
For some reason the micro SD card in the BDP-Pi became unwritable, hence the checksum error.
I add to buy a new card and download an old version of MM on it following the instructions here:
http://support.bryston.com/downloads/BD ... ources.pdf

Then The BDP Pi accepted the upgrade.

Re: BDP-Pi Firmware update failing

Posted: Mon Nov 19, 2018 6:01 pm
by Chris Rice
That repair is covered under the units warranty, if you contact us with the units serial number and an address we can either send out a replacement or direct you to the nearest overseas Bryston distributor.

Re: BDP-Pi Firmware update failing

Posted: Mon Nov 19, 2018 6:02 pm
by Chris Rice
martydmnt wrote:
My Pi is letting me know a new version of the firmware is available. I currently have S2.38 2018-09-11 installed. When I go to Firmware update from the Dashboard, I click on "Update." It dutifully downloads the new firmware but it fails the checksum (see the screenshot). I've tried several times over the past 2 weeks and the result is always the same. Any help is appreciated, thanks!


If you place the BDP into service mode and email us the service id we can confirm the state of the BDP's internal storage.

http://support.bryston.com/downloads/BD ... Manual.pdf

Chris