Page 1 of 1

Scratch disk almost full, but can't set a new scratch disk

Posted: Thu Apr 18, 2019 1:52 am
by martydmnt
Chris, it seems no matter what problem could be had I will eventually run into it. I recently added a bunch of music from my Mac to the usb drive attached to the Pi. After rsync'ing the files, I used the Update function on the Pi. As it was rebuilding the database, I got an error that the scratch disk was almost full (at 94%) and I should set a new one. When I attempted to do so, I received the error "Can not use a system volume as the scratch drive." I get this whether I use a small partition on the external usb drive or if I use a thumb drive plugged into the Pi.

Any help would be appreciated! I coiuld clear the cache, I suppose, but I did add a bunch of artwork to the database and would prefer not to do that if it could be avoided.

Thanks!

Re: Scratch disk almost full, but can't set a new scratch di

Posted: Mon Apr 22, 2019 7:52 pm
by Chris Rice
Please place the unit into service mode and email me the service id

http://support.bryston.com/downloads/BD ... Manual.pdf

Thanks
Chris

Re: Scratch disk almost full, but can't set a new scratch di

Posted: Wed Apr 24, 2019 4:52 pm
by martydmnt
Thanks, Chris, email sent.

Re: Scratch disk almost full, but can't set a new scratch di

Posted: Wed May 22, 2019 9:46 pm
by martydmnt
Everything seems to be working fine with the new firmware update, which I just installed today. Great work, thanks Chris!