Settings - Audio Device

Discuss Bryston's BDP-2 Digital Music Player

Settings - Audio Device

by Nazzareno » Mon Nov 04, 2019 12:43 pm

In the Settings Menu I tried to enter Audio Device to check the settings.
Going down to "ADVANCE" I realized the output volume is allways at 86%, resulting in a lower output level from the loudspeakers.
I try to explain what I am meaning:

entering the advance menu a ALSA MIXER WEBUI PAGE shows a SPEAKER PLAY BCACK two cursors (Front Left and Rigth channels) the are set at 86% of max. It is the level of volume sent to the DAC of the preamp.
The system allows to change, so I set both the cursor at 100%.
It is soon evident cose the higher volume from the loudspeakers.
Exited from the page and confirmed the change and heard music for some time.
Now the level remains at maximum (100%) until thy BDP-2 is turned off. When it is turned on again, the levels above are again at 86%.

I ask Chris, is there is any reason for this? Can I do the change permanently and how?
Aslo in ADVANCE, entering USB MIXER there are two options one is that I described before with two cursor, and anothe in whic there is only only one (front left) BRYSTON CLOCK SELECTOR PLAYBACK . Can please explain the function?

Thank you and sorry for my English.....

Nazzareno
Nazzareno Lelii
Ascoli Piceno ITALY
Nazzareno
 
Posts: 7
Joined: Thu Nov 29, 2018 2:44 pm
Location: Ascoli Piceno - Italy

Re: Settings - Audio Device

by Nazzareno » Tue Nov 19, 2019 6:39 pm

No one that can answer?.....
Nazzareno Lelii
Ascoli Piceno ITALY
Nazzareno
 
Posts: 7
Joined: Thu Nov 29, 2018 2:44 pm
Location: Ascoli Piceno - Italy

Re: Settings - Audio Device

by Lwxian » Sun Nov 24, 2019 3:47 am

Ha ha... I think that advance function should be a work in progress... my usb mixer only shows front left and not front right. But audio output via usb is fine.
Lwxian
 
Posts: 10
Joined: Sat Oct 04, 2014 3:29 am

Re: Settings - Audio Device

by Nazzareno » Tue Nov 26, 2019 10:41 am

Hi,
yes me too supposed the same....
My question however was if there is any way to adjust the output level in the SPEAKER PLAY BACK function, in which there are two cursors, for left and right channels, allways set at 86% of max.
If I try to adjust them to 100%, they remain at 100% until the BDP-2 remains on. It will reset at 86% next time it is turned on again.
I would like, if it is possible, to adjust permanently the level of the speaker play back.
Ciao

Nazzareno
Nazzareno Lelii
Ascoli Piceno ITALY
Nazzareno
 
Posts: 7
Joined: Thu Nov 29, 2018 2:44 pm
Location: Ascoli Piceno - Italy


Return to BDP-2

Who is online

Users browsing this forum: No registered users and 0 guests

cron