BDA-3 Stuck in USB function

Discuss Bryston's BDA-2 DAC

BDA-3 Stuck in USB function

by appdevman » Wed Mar 01, 2017 10:43 pm

Hi all
I have a BDA-3 for a year, initial connection USB, and remained USB for the year.

I just tried other inputs, and they don't work (TOSLINK and HDMI).

I power cycled the unit (by removing cord physically and waiting 2 minutes), but it is still stuck.

Any suggestions?

Error and status messages:

I2C bus hung!
USB INT is stuck
I2C RD timeout
EEPR SourcePar not init
EEPROM fault
EEPROM check failed
Past Critical T
appdevman
 
Posts: 4
Joined: Fri Feb 24, 2017 4:42 am

Re: BDA-3 Stuck in USB function

by stanb » Fri May 05, 2017 4:55 pm

I would suspect a possibility of a hardware problem, such as one of the internal cable connections came out of its header etc, but I am not 100% sure.
That would explain why you cannot switch, for example to HDMI source.

What is the firmware revision? You can view on the web GUI, unless the ethernet interface has crashed as well. I would recommend to update the software, unless it is already recent, for example 2016.05a or later. If you need to update, please let me know, I will send you the file but I need to know more details because some system may require special programming. Also I need to know the result of the "%2330INFOQS." command. If you can run in in the terminal tab of the web interface, you can then copy and paste it to an email and send to us. My email is sb at bryston dot com.

Stan Bleszynski, Bryston
stanb
Site Admin
 
Posts: 24
Joined: Mon Jan 12, 2015 4:07 pm
Location: Bryston


Return to BDA-2 DAC

Who is online

Users browsing this forum: No registered users and 1 guest

cron